How to Activate a Dehydrated Sourdough Starter — Day-by-Day Guide
Share this article
A dehydrated starter is the same living culture as our live starters, dried at low temperature so the wild yeast and lactic acid bacteria go dormant. Activating it means waking those microbes up with water, flour and warmth, then feeding daily until the culture is strong enough to raise bread. Most bakers are ready in 2–4 days. This guide covers every step, what to expect each day, and what to do if it's slow.
The short version
- Day 1: stir 20g powder (the whole sachet) into 40g lukewarm water until smooth. Add 20g flour, mix well, cover loosely and leave somewhere warm.
- Every 24 hours after that: keep 20g of starter, discard the rest, and feed it 20g flour + 20g water.
- Ready to bake when it doubles within 4–12 hours of a feed, is bubbly throughout and has a domed top. Usually by day 2–4.
Ideal temperature is 24–28°C. Use the same flour as your culture: unbleached baker's flour for wheat, whole rye flour for rye.
Before you start
You don't have to start straight away
Unlike a live starter, the sealed sachet will wait. Store it in a cool, dry place out of direct sunlight and use it within 12 months of the packing date on the label. There's no need to refrigerate it. If you've received it as a gift, start whenever suits you.
What you'll need
- Your dehydrated starter (20g sachet)
- A clean glass jar of around 500ml — our mason starter jar has a stick-on thermometer, which helps a lot during activation
- A kitchen scale that reads in grams
- Flour matching your culture: unbleached baker's flour (above 11% protein) for wheat, organic whole rye flour for rye
- Filtered water, or tap water that has stood uncovered for at least an hour so the chlorine can dissipate
- A spoon or silicone spatula for mixing and scraping down the jar
Not sure which flour to buy? Our Sourdough Flour Guide lists what works and where to find it in Australia.
Day 1 — Rehydrate and give the first feed
Step 1 — Weigh the empty jar
Place the clean, empty jar on your scale and note the weight. Write it on the bottom of the jar with a permanent marker — it makes every future feed easier. Then zero the scale.

Step 2 — Dissolve the powder in water
Add 40g of lukewarm water — warm to the touch, around 25–30°C, never hot. Tip in the whole 20g sachet and stir until there are no dry lumps. Letting it sit for 15–30 minutes before the next step helps the powder soften fully, but it isn't essential.
Step 3 — Add the flour
Add 20g of flour and mix thoroughly until no dry flour remains. Scrape down the sides of the jar so nothing is left stuck above the surface — old starter on the walls is where contamination usually begins. You'll have about 80g in the jar.

Step 4 — Cover loosely and keep it warm
Rest the lid on top without tightening it, so fermentation gases can escape. Leave the jar somewhere warm, ideally 24–28°C. If your kitchen is cool, try the top of the fridge, near a warm appliance, or inside the oven with only the light on. A rubber band around the jar at the starting level makes it easy to see any rise.

Don't expect much on day 1. A few small bubbles is a good sign, but no activity at all is completely normal at this stage.
Day 2 onwards — Feed every 24 hours
Once a day, at roughly the same time:
- Stir the starter, then discard all but 20g (anything from 20–30g is fine).
- Add 20g flour and 20g lukewarm water — equal weights of starter, flour and water.
- Mix well, scrape down the jar walls, cover loosely and return it to its warm spot.
Don't skip feeds during activation. Consistency matters more than anything else in these first few days. The discard from the first couple of days is still weak, so don't use it to raise bread — it's fine in discard crackers or pancakes, or it can go in the compost.
What to expect, day by day
| Day 1 | Little or no visible activity. Perhaps a few small bubbles. |
| Day 2 | Bubbles appear and the starter may rise slightly. The smell becomes noticeably sour. |
| Day 3 | A clear rise within 12 hours of feeding, with bubbles through the mixture. |
| Day 4 | Doubles within 4–12 hours of a feed and smells clean and tangy. Most starters are ready to bake with here. |
Rye usually wakes up faster than wheat. Below 20°C everything slows down, so a cool kitchen can add a day or two. That's not a sign anything is wrong.

How to tell it's ready to bake
Your starter is fully activated when it:
- Doubles (or more) in volume within 4–12 hours of a feed
- Shows bubbles throughout, not just on the surface
- Has a domed top at its peak
- Smells pleasantly tangy and sour rather than sharp or harsh
For the best result, wait until it has done this on two feeds in a row. Baking with an underactive starter is the most common cause of a dense, gummy first loaf.

Use it at or just before its peak. Most recipes call for starter equal to 15–20% of the total flour weight. If you need more than you have, build a levain first — our Starter Care Guide explains how. When you're ready, our Classic Sourdough Bread recipe is written for exactly this point, and wheat starter owners may want to start with our sourdough pizza dough.
Troubleshooting
Nothing is happening after day 1
Normal. The microbes are rebuilding their numbers from a dormant state and it takes a couple of feeds before you see much. Keep feeding every 24 hours.
Still no rise after 4 days
Almost always temperature. Check the jar thermometer and move it somewhere warmer if it's below 20°C. Then check the basics: unbleached flour of the right type, filtered or rested water, lukewarm (not hot) water, and no skipped feeds. A cool kitchen can stretch activation to 5 days or so. If you've had a week of warm, consistent feeding and still see no bubbles at all, text us and we'll work through it with you. Our guide Why Isn't My Starter Rising? covers every cause in detail.
Bubbles, but it doesn't rise
The starter is probably a little too runny for the gas to lift it. Reduce the water by a few grams on the next feed. Wheat should look like thick batter; rye like loose peanut butter.
It smells like nail polish, paint or vinegar
Common in the first few days, especially with wheat starter. It means the culture is hungry and still finding its balance. Keep feeding on schedule and the smell settles into a clean, tangy aroma.
There's grey or dark liquid on top
That's hooch, a harmless by-product of a hungry starter. Pour it off or stir it in, then feed. If it keeps appearing, the jar is somewhere warm enough that it needs feeding slightly earlier.
It rose and fell before I checked
Look for a ring of residue on the jar above the current level, or check where it sits against your rubber band. If it rose and collapsed, that's an active starter — you just missed the peak.
Fuzzy spots, or pink or orange patches
That's genuine contamination and the starter should be discarded. Clean the jar with hot water and vinegar, and get in touch. For help telling contamination from normal surface activity, see Is My Starter Healthy?
Common questions
Can I activate only half the sachet?
Yes. Use 10g powder, 20g water and 10g flour on day 1, then feed as normal from day 2. Reseal the rest tightly and keep it in a cool, dry cupboard as a backup.
Can I use plain flour?
Avoid it during activation. Plain, bleached and self-raising flours are weaker and can contain additives that slow the culture down. Once the starter is established you can experiment more freely.
Do I need to feed it twice a day?
No. Once every 24 hours is enough for activation. In a very warm kitchen above 30°C it may peak and collapse quickly, which is fine — our guide to sourdough in Queensland heat covers how to slow it down.
Can it go in the fridge during activation?
Not yet. Keep it at room temperature until it's doubling reliably. After that it can live in the fridge between bakes.
Once it's active
From here, an activated starter is exactly the same as a live one. Feed it once a day if it lives on the bench, or once a week if it lives in the fridge. Everything about routine feeding, storage and troubleshooting is in our Sourdough Starter Care Guide, and our Step-by-Step Feeding Guide shows each feed in photos.
It's also worth drying a little of your active starter as a backup, so you can always rebuild the same culture. How to Pause Your Sourdough Starter shows how.
Stuck at any point? Every starter comes with ongoing support. Text us with a photo of your jar and we'll tell you what it's doing.
